high detail Fokker DVIIF 185hp BMW.
Some features are: full 3D cantilever (internal bracing) wings; new and more realistic pilot; all control surfaces (balance surfaces included) pivot around the historical correct axis; new realistic 3D prop; lozenge pattern on the top of the fuselage; new realistic damage on top wing.

I maintained the original S/D bitmap system. This zip contains adapted bmps for the standard German DVII.
To fly this plane, you'll need some additional parts of FPSPP.zip.
The piDVII.bmp is not needed when you use the dml-file between brackets. The difference between the two dml files is a shaded leatherlook pilot versus a more classic RB look.
dam1.bmp is a new bmp used for more realistic damage and will be used in the future for several planes.

***painting issues***

I made some changes in the texture positioning of the fuselage. 
First: the bottom line. It's always difficult to obtain a sharp edge between the side and bottom painting. I have found a solution to this. Just below the bottom line of the sides, I ignore a 2 pixel line and then use the next line for the bottom. This makes the positioning of the bottom line less critical and gives a very sharp edge.
Second: the lozenge pattern on the top of the fuselage. In normal conditions this is almost impossible. But I use a new trick: I wrap the bitmap around the top (only the section behind the cockpit). And I do it linear, so you don't get an effect of narrowing spots.
Third: I use the same technique for the engine. The engine bitmap - sides and top - is included in the fuselage bitmap.

If you study the dml-file, you'll notice the mtstr2.bmp is used twice: for all struts and for all other metal parts. This gives you the opportunity to paint the struts without painting all other metal parts.
The sides of the axle wing are painted with the left bottom pixel of the fuselage bmp. (similar as POYD)


29/03/2001
Charles de Thielt


